► Find more details, circuit schematics and source codes from my official website.
In this Arduino LCD Tutorial we will learn how to connect an LCD (Liquid Crystal Display) to the Arduino board. LCDs like these are very popular and broadly used in electronics projects as they are good for displaying information like sensors data from your project, and also they are very cheap.
Visit HowToMechatronics.com for more Tutorials, Tips, Projects and How It Works videos:
►
Like my page on Facebook:
►
Add me on Google+:
►
Music used: Aduro by Jens Kiilstofte (machinimasound.com/music)
Circuit schematics made in: Fritzing
Nguồn:https://mcitmc.org/
Xem Thêm Bài Viết Khác:https://mcitmc.org/cong-nghe/
Do the lcd and Arduino need to be connected to the same ground?
Hatsup to u sir very very simply understandable
Can this tutorial work with Arduino Uno too?
Do you need all the pins? like if I don't want to change the contrast can I leave out pin Vo?
Do the D3-D7 slots have to be plugged into PWM slots?
does it matter which side of the potentiometer goes into positive and negative rails?
I have a question: If I don't have a 1K potentiometer, can I use a 10K and it still work?
thancC!!111!!!11
How can we use them to display the angles ?
best tutorial for lcd
Thank you!
How can i create more custom characters?
Was my potentiometer supposed to start smoking?!
Thanks for such a short helpful video!
Y 7 is used in
Lcd.createchar
if you made the name from lcd to like abc or something would the command look like abc.print()?
Is this C++ or C? I'm new to the Arduino and plan on using it for a simple little project. I have a bit of experience with C++. Thanks for your response! 🙂
I tried LCD on simulator. Whenever i connect LCD anode and cathode to + and – , it explodes.
Then i tried it with potentiometers, it still exploded but only at far end position of the potentiometer.
Do you usually connect anode with resistor or potentiometer?
Awesome! I had no idea how to do it but I know now how to do it!
Will be connected toooo x3 + times
Dommage je ne comprends pas suffisamment la langue mais les explications visuelles semblent suffisantes. Merci
Thanks a lot
You would have gotten a vote if you included the use of a virtual buffer.
the tutorial was explained very well, and it is probably one of the best ever but I did the circuit and the code and I checked it 5 times can I have some advice on what to do now (reply below)
helped me a lot. I understood it clearly. could use it to read my joystick X , Y value.